Nobody specifies a job around its connection pieces. They are, however, the parts that decide whether the unit hangs square, whether the condensate drains, and whether anyone can get a filter out in three years' time.
Getting the duct onto the unit
Duco connection pieces with joint come in matched and stepped sizes so the spigot meets the duct without a sleeve of tape: D125/D125, D160/D125, D160/D160.
Larger units take D180/D160 and D180/D180. On the cold ODA and EHA lines, use the insulated version so the insulated envelope is not broken at the unit.
Changing size and splitting runs
A reducer 160 to 125 steps a trunk down to a branch. A breech Y-piece, 2 x 125 to 1 x 160 merges two runs into one with a far lower pressure penalty than a square tee.
A 125 mm duct flange finishes a duct at a plenum or a panel.
Mounting the unit
Mounting chairs take the unit's weight and set it level, which matters because an out-of-level MVHR unit will not drain.
There is a hanging frame and a standing frame for Energy Premium, and a standing frame for the Energy Comfort D325.
Leave filter access clearance when you set the height. It is the single most common thing to regret.
Condensate
Heat recovery condenses water, and that water has to leave.
The flat siphon for DucoBox Energy provides the trap in the drain without demanding the vertical depth a conventional siphon needs, which is what makes it usable under a floor-standing unit in a normal cupboard.
Finishing at the room
At the room end, the 125 mm plasterboard sleeve for DucoVent gives the valve a clean, rigid seat in a plasterboard ceiling instead of a ragged hole.
Pair it with the right valve from our DucoVent air valve comparison.
Specifying
Send the unit model and the duct sizes and we will put the fittings list together. Browse Duco ventilation accessories or call 01283 380031 | sales@pureclima.co.uk.

