Skip to content

Free Ventilation estimate  01283 380031 

✌🏼 Next Day Delivery

Cart
Accessories

DucoFlex Duct Cutters, O-Rings and Couplings

A ventilation system meets its design airflow or it does not, and the difference is rarely the unit. It is usually the joints: duct cut square or cut ragged, O-rings seated or pinched, couplings pushed home or left half an inch short.

Cutting duct square

Semi-rigid duct cut with a hacksaw leaves a burr and an oval end, and neither seals. The dedicated cutters match the three duct sizes: D63, D75 and D90.

One cutter per duct size on site is cheaper than one remedial visit. If a job runs two sizes, buy two. Our guide to choosing a semi-rigid duct size covers which you will be running.

Sealing the joint

Rubber O-rings are what make a DucoFlex joint airtight, and they are consumable: one gets nicked, one walks off, one is already in the wrong size. They come in packs of ten in D63, D75 and D90.

Check the ring is seated in its groove and not rolled before the joint goes together. A rolled O-ring leaks and you will not find it once the ceiling is on.

Joining lengths

Couplings join two duct lengths or repair a run that was cut short, in D63, D75 and D90. Keep a few on the van: the alternative to a coupling is usually a whole new length.

Quieting a DucoBox

Structure-borne noise is the complaint you get months after handover. The Silent Plus Kit adds three damping pads and three caps to a DucoBox Silent or Focus, isolating the unit from the surface it is fixed to.

Fit it at installation rather than as a remedial measure. Taking a commissioned unit off the wall to slide pads under it is an afternoon nobody has budgeted for.

Focus system kits

For a DucoBox Focus install, two bundles save line-by-line specifying: the Focus System Basic Kit with control valves, user controller and Silent Plus kit.

Where bedrooms are extracted as well, the Basic Kit with Bedroom Extraction carries five control valves and a user controller instead.

Specifying

Tell us the duct sizes and the number of terminals and we will add the right cutters, O-rings and couplings to the schedule. Browse ductwork accessories and tools or call 01283 380031 | sales@pureclima.co.uk.

Previous Post Next Post

Leave A Comment