Skip to content

Free Ventilation estimate  01283 380031 

✌🏼 Next Day Delivery

Cart
DUCO

DucoFlex Flat Oval Duct: Ventilation in Shallow Voids

Round duct is better aerodynamically. It is also 125 mm tall, which is 125 mm you often do not have. Flat oval duct exists for floor screeds, shallow ceiling voids and service zones where the build-up was fixed long before the ventilation was designed.

The duct

DucoFlex rigid oval ducting is 163 mm wide, 68 mm high and 1150 mm long. That 68 mm is the number that decides whether a route is possible at all.

Changing direction

Oval duct bends in two planes and needs a different fitting for each. The horizontal elbow covers 90 and 45 degree turns in the flat plane; the vertical elbow turns the duct up or down on edge.

Joints between lengths use the oval duct coupling, and any unused leg gets an oval end cap rather than tape.

Getting back to round

Oval is for the constrained section, not the whole system. Horizontal connectors convert back to round at D125 or 2 x oval to D160.

The riser duct connector takes a round D160 riser into two oval legs where a duct drops down a service shaft.

Feeding semi-rigid branches

Where oval duct feeds the semi-rigid radial system, oval adapters make the transition: 3 x 63, 2 x 75, 3 x 75 and 2 x 90.

Our guide to choosing a semi-rigid duct size covers which branch size to run.

The trade-off to design around

Flat duct has more surface area per unit of airflow than round, so pressure drop per metre is higher.

Use it for the section that needs to be shallow, not for the whole run, and keep the velocity down by using two legs rather than squeezing everything through one.

Specifying

Send the void depth and the route and we will work out the layout. Browse oval ducting or call 01283 380031 | sales@pureclima.co.uk.

Previous Post Next Post

Leave A Comment